Gas Turbine Engines on Rc Toy Jets - How Do They Work?

A lot of hype has been going colse to the gas turbine powered engines found on high-end Rc toy jets. These new breed of Rc toys promise to dominate the skies in the arrival years since the interest on these newest radio controlled aircraft seem to be gaining ground. This is despite the fact that these singular types of toys also seemed poised to cause a huge dent in everyone's wallet. It appears now that Rc enthusiasts and hobbyists cannot seem to get adequate of the new gas turbine powered engines on toy jets. So what is certainly all the excitement about? How do these gas turbine engines on Rc toy jets work anyway?

For any decades, men have been fascinated by Rc toy planes and helicopters. They love to watch it lift off the ground, play tricks in the air, and perform a exquisite landing. Most of Rc toy planes in the past are propeller driven because they are seen to be the most practical arrival to make the plane fly. So it would be not surprising back then if you see a scaled down model of a jet fighter with a propeller on its nose tip. This went on for a long time until July 30, 1988, the first flight of an toy jet running on micro-turbojet engines was made with requisite success. From then on, micro-turbojets underwent a series of evolutions and finally, the contemporary gas turbine engines, which are being mounted on Rc toy jets that you now see, emerged.

RC Helicopter

Gas turbine engines on Rc toy jets work in a manner similar to that of real jet turbine engines. There are three divisions on the gas turbine engines and these are the compressor, the combustion chamber, and the turbine. The compressor is responsible for sucking incoming air and compressing them inside the cylindrical shroud. Extreme compression results in the heating up of air which then makes its way down into the combustion room where a fine spray of fuel, along with a glow plug, will be introduced in the area.

Just as expected, the fuel, mixed with hot compressed air and lit by a glow plug, will explode, forcing the exhaust gases out through the turbine and the small nozzle found at the rear of the jet turbine. This chain reaction produces the gigantic thrust that enables the Rc toy jet to take off and fly. Since the turbine and the compressor are associated by a coarse shaft, the expelled gas which turns the turbine is also the one that drives the compressor. This is why the gas turbines must be powered at the outset by an external source until the air inside the combustion room is adequate and adequately heated.

So you see, gas turbine engines on Rc toy jets work just like their real and full scale counterparts. It might just differ in size but the principle on how they work is basically the same.

Gas Turbine Engines on Rc Toy Jets - How Do They Work?

Visit : หางานเชียงใหม่ TV With Inernet review of blu ray players VIZIO High definition TV